Crime and Clues


The Art and Science of Criminal Investigation
Home | Back | Contact

Contents

Fingerprinting the Dead

by Daryl W. Clemens


Plastic tape.



"Camel hair" brush.



Powder fingers.



Press tape firmly against finger.



Place clear tape on front of fingerprint card, or use
white tape and place on the back of clear acetate cards.



Close-up of lifted reference print.


Obtaining fingerprints for identification is a long established law enforcement practice. When the practice started, is was most common to use printers ink applied to the fingers which were then pressed onto paper cards. Later specialized inks were employed to improve the quality of the prints obtained. While ink is still used today, many agencies are now using computer "live-scan" methods to record reference prints.

One of the challenges in obtaining reference prints has always been how to obtain them from the deceased. Ink has often been used with success, but it can be difficult, especially with rigor stiffened or mummified fingers. Live-scan is not a practical option, at least not until someone develops a portable scanner.

One method that has been used is to obtain prints using black fingerprint powder (normally used to locate latent fingerprints at crime scenes). The method is simple, reliable and works on stiff and mummified fingers.

Materials needed are a small jar of black fingerprint powder, clear or white plastic tape ("Scotch" brand is pictured here, but any similar flexible tape will work), a small "camel hair" brush, and either white fingerprint cards or clear acetate cards depending on whether you choose clear or white tape.

Apply the powder to the fingers, and brush off any excess. It is easiest to next cut 10 small sections of tape, rather than wrestling with tape still on the roll. Press the tape firmly against the finger, starting in the center and working outward. Remove the tape and place it on a fingerprint card. Clear tape can be applied to the front of standard cards, or white tape can be applied to the back of clear acetate sheets. Important note: Prints obtained using clear tape applied to the front of standard cards will not be in the same orientation as standard inked prints and will need to be reversed before classification or entry into automated systems.

Severely wrinkled fingers can be powdered fairly easily, but may need to be cast with Mikrosil instead of lifted with tape.

Ernie Hamm also suggests that white contact paper can also be used in place of white tape, and that it can be cut in pieces large enough to record palm prints as well. Thanks Ernie!

Google
Web www.crimeandclues.com




Home | Back | Contact

Crime & Clues- http://crimeandclues.com Source Code & Layout Copyright ©1998-2006 Daryl W. Clemens
No Claim to Original U.S. Government Documents